CUTES CT-2000FG Series - Page 32

32
6. Constant tables ■
Constant
NO
Name Description
Setting
value
Factory
setting
Change
during
operation
Com.
add.
Page
Cd-89
Analog output 1
(FM) gain
Set voltage amplify magnification of operation
frequency analog output
0.01
󲕏2.50
1.00 Yes 555 P50
Cd-90
Analog output 2
(AM) bias
Set voltage bias value of operation current analog
output, 10V is 100%
±10.0% 0.0% Yes 556 P50
Cd-91
Analog output 2
(FM) gain
Set voltage amplify magnification of operation
frequency analog output
01
󲕏2.50
1.00 Yes 557 P50
Cd-92
Multifunction
terminal S1
function
0󲕏21 9 No 558 P51
Cd-93
Multifunction
terminal S2
function
0󲕏21 10 No 559 P51
Cd-94
Multifunction
terminal S3
function
0󲕏21 2 No 560 P51
Cd-95
Multifunction
terminal S4
function
0󲕏21 8 No 561 P51
Cd-96
Multifunction
terminal S5
function
0󲕏21 1 No 562 P51
Cd-97
Multifunction
terminal S6
function
0: 3-wire operation control
1: Multi-step speed 1
2: Multi-step speed 2
3: Multi-step speed 3
4: Reserved
5: JOG frequency
6: Forward JOG
7: Reverse JOG
8: Auto restart attempts
9. Multi-steps acceleration/ deceleration time 1
10: Multi-steps acceleration/ deceleration time 2
11. PID control disable
12. PID integration control reset
13. PID integration control maintain
14. PIDsoft start
15. Switch PID error input characteristics
16. Not used
17. PLC reset
18. Emergency stop
19. Coast stop
20: Electrical adjustable speed UP
21: Electrical adjustable speed Down
0󲕏21 19 No 563 P51
Cd-98 Lock data
0: Lock data (read only)
1: Data is variable (simple)
2: Data is variable
0󲕏2 2 Yes 564 P90
Cd-99 Initialize data
0: invalid
1: Only recover PLC constant
: Recovering Factory value, uncontain PLC constant
. Recovering Factory value, uncontain motor and
PLC constant
4. All constants recover factory value
5: Eliminate malfunction record
0󲕏5 0 No 565 P94