CUTES CT-2000FP-2-022 - Page 29

29
6. Constant tables ■
Constant
NO
Name Description
Setting
value
Factory
setting
Change
during
operation
Com.
add.
Page
Cd-44 Stop mode
Set stop mode when send command
0: Deceleration stop
1: Free run stop
Free run stop, but restart after the deceleration time
is reached.
0󲕏2 0 No 172 P46
Cd-45
Frequency detect
level
Set multifunction relay and DO frequency active
point
0󲕏400.00
0.50
HZ
No 173 P55
Cd-46
Speed multiplier/
gears ratio
RPM is indicated on the screen 0󲕏150.00 1.00 Yes 174 P87
Cd-47
Multifunction
relay 1
output function
selecting
1󲕏9 1 No 175 P55
Cd-48
Multifunction
relay 2
output function
selecting
1󲕏9 7 No 176 P55
Cd-49
DO output
function
selecting
0: Timer(act when RUN time reach to Cd29 value)
1: Malfunction
2: Stopping
3: Acceleration
4:Speed agree
5: Deceleration
6: Frequency arrive ( operation frequency > Cd45
value)
7: Current arrive (compares to Cd85and Cd86 value)
8: Overheat (Cd82) predict action
9: OL malfunction action 10: x
1󲕏9 8 No 177 P55
Cd-50
Torque boost
delay time
The torque boost delay time is set in ms units. Set
torque boost primary delay time constant.
Adjust in the following circumstance:
1. When the motor is oscillating, increase the set
values.
2. When the responsiveess of the motor is low,
decrease the set values.
0󲕏10000
50m
sec
No 519 P61
Cd-51
Motor rated
voltage
Each factory value of each model
50.0󲕏
500.0V
By
spec.
No 527 P60
Cd-52
Motor rated
frequency
10.0󲕏
400.0
60.0
Hz
No 528 P60
Cd-53
Maximum output
frequency
10.0󲕏
400.0
60.0
Hz
No 529 P60
Cd-54 Maximum voltage
10.0󲕏
500.0V
By
spec.
No 530 P60
Cd-55
Middle output
frequency
0.0 󲕏
400.0
3.0
Hz
No 531 P60
Cd-56
Middle output
current
0.0 󲕏
500.0
By
spec.
No 532 P60
Cd-57
Minimum output
frequency
0.0 󲕏
400.0
0.5
Hz
No 533 P60
Cd-58
Minimum output
voltage
Set V/F curve, please adhere the following rules:
Cd53≧Cd52>Cd55≧Cd57
Cd54≧Cd51>Cd56≧Cd58
0.0 󲕏
500.0
By
spec.
No 534 P60