Cutler-Hammer I.B. 8926-1A
Model A
Effective 3/01
Freedom 2100 Motor Control Center
Installation and Maintenance Manual
TABLE OF CONTENTS
PART DESCRIPTION PAGE
1 General Information 2
2 Receiving, Handling, & Storage 4
3 Installing Control Center Sections 5
4 Installing Conduit & Wiring 10
5 Incoming Line Connections 12
6 Overcurrent Protection Devices 14
7 Overload Relay Heater Selection 16
8 Inspection Prior to Energizing 19
9 Unit Installation & Adjustment 20
10 Maintenance 23
11 Plan Views 31
12 Related Instruction Leaflets 33
This electrical control equipment is designed to be
installed, operated, and maintained by adequately
trained workmen. These instructions do not cover all
details, variations, or combinations of the equipment, its
storage, delivery, installation, check-out, safe operation,
or maintenance. Care must be exercised to comply with
local, state, and national regulations, as well as safety
practices, for this class of equipment. The maximum
short circuit capability of the equipment should not be
exceeded by connection to a source with higher
capacity.
If maintenance or troubleshooting assistance is required,
contact your nearest Cutler-Hammer Sales Office.
To Next Page
Need help?
General