3. Operate the unit at all levels to verify proper operation.
E3 View Monitor
Tools Required:
• Phillips screwdriver
• 11/32” Nut driver
• ESD (Electrostatic Discharge) grounding strap
Disconnect power source
Unplug the power cord from the power outlet.
Shock and electrocution hazard.
• Unplug unit and let sit 10 minutes before cleaning or performing
maintenance.
• Electrical charge can remain in unit after unplugging.
• Keep water and liquids away from electrical parts.
Remove back cover
Remove four screws securing back cover to console assembly using a Phillips screwdriver.
Qty.DescriptionItem
1Console Assembly1
1Back Cover2
4Screws3
Remove E3 View Monitor
1. Unplug IR receiver cable from E3 View Monitor.
Page 184 of 199
Cybex 525T Treadmill Part Number
To Next Page
Loading...
