CYBEX 770T - Page 132

Remove rear roller
1. Remove the two rear roller bolts, washers, bushing and rear roller nut (one roller bolt on each side)
using a 3/4” Socket wrench.
Loosen each bolt evenly, making sure not to loosen either bolt too many turns before moving to the
other bolt.
Qty.DescriptionItem
1Rear roller nut1
1Rear roller2
1Bushing3
1Washer4
1Bolt5
2. Lift one side of the rear roller and slide the roller out of the running belt.
Remove front roller
1. Loosen the left mounting bolt using a 9/16” Socket wrench.
Qty.DescriptionItem
1Front roller1
1Drive belt2
1Mounting bolt3
1Tensioning slot4
2. Loosen the right mounting bolt using a 9/16” Socket wrench.
3. Remove both mounting bolts.
4. Slide the drive belt off of the front roller and remove the front roller.
Install front roller
1. Slide the front roller into the running belt.
Page 132 of 261
Cybex 770T/790T Treadmill Part Number