CYBEX 770T - Page 177

Remove shield
1. Loosen, but do not remove the seven screws securing the shield to the base using a Phillips
screwdriver.
Qty.DescriptionItem
1Base1
7Screws2
1Shield3
2. Remove shield by sliding sideways and then vertically off of base.
Disconnect cables from motor controller
Pulling cables by their wires can damage the cables. Remove cables by pulling from connectors.
Carefully un-latch the cable connectors from the motor controller. This includes; the power in (INPUT),
display cable (COMM.), elevation cable (INCLINE), drive motor cable (OUTPUT) and resistor (DB).
Qty.DescriptionItem
1Power In (INPUT)1
1Display Cable (COMM.)2
1Elevation Cable (INCLINE)3
1Drive Motor Cable (OUTPUT)4
1Resistor (DB)5
Page 177 of 261
Cybex 770T/790T Treadmill Part Number