CYBEX 770T - Page 179

Connect cables to motor controller
1. Connect the cables to the motor controller.
This includes; the power in (INPUT), display cable (COMM.), elevation cable (INCLINE), drive motor
cable (OUTPUT) and resistor (DB).
Qty.DescriptionItem
1Power In (INPUT)1
1Display Cable (COMM.)2
1Elevation Cable (INCLINE)3
1Drive Motor Cable (OUTPUT)4
1Resistor (DB)5
2. Ensure all cables are connected firmly and securely in their proper place.
Install shield
Using a Philips screwdriver tighten the seven screws securing the shield to the base.
Qty.DescriptionItem
1Base1
7Screws2
1Shield3
Page 179 of 261
Cybex 770T/790T Treadmill Part Number