CYBEX 770T - Page 183

Remove On/Off switch
Take notice of which cables are connected to the On/Off switch.
1. Disconnect the six fast-on connectors that connect to the On/Off switch.
Qty.DescriptionItem
1To power inlet (White)1
1To power inlet (Black)2
1On/Off switch3
1To line filter (Black)4
1To power supply (Brown)5
1To power supply (Blue)6
1To line filter (White)7
1
Position On/Off switch as
shown
8
2. Press in the sides of the On/Off switch to remove it from the base plate using a flat head screwdriver.
Qty.DescriptionItem
1On/Off switch1
1Base plate2
1Side plate3
Install On/Off switch
Position On/Off switch as shown.
1. Insert the On/Off switch into the hole in the base plate.
Qty.DescriptionItem
1On/Off switch1
1Base plate2
1Side plate3
Page 183 of 261
Cybex 770T/790T Treadmill Part Number