Install Cybex GO monitor cables
1. Plug the power, ethernet cable, and control board cable into the Cybex GO monitor.
Qty.DescriptionItem
1Power cable1
1Cat6 ethernet cable2
1Coax cable3
1Control board cable4
2. Screw the coax cable into the Cybex GO monitor.
3. Install the ground cable to the Cybex GO monitor using a 11/32” nut driver.
Install fan
1. Install six screws securing fan and duct to console assembly using a Phillips screwdriver.
The louver is held in place with the duct.
Qty.DescriptionItem
1Console Assembly1
1Louver2
1Duct3
6Screw4
1Fan5
Page 214 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
