Remove wireless heart rate board
The wireless heart rate board is installed with double sided tape. Remove only if replacing with a new
wireless heart rate board.
1. Unplug the wireless heart rate cable by un-latching connector from the wireless heart rate board.
Qty.DescriptionItem
1Wireless Heart Rate Cable1
1Wireless Heart Rate Board2
2. Pry the wireless heart rate board from the console using a flat head screwdriver.
3. Clean any remaining double sided tape from the console.
Install wireless heart rate board
1. Locate the new wireless heart rate board.
2. Peel the backing from the double sided tape and place the wireless heart rate board in position on
the console.
Qty.DescriptionItem
1Wireless Heart Rate Cable1
1Wireless Heart Rate Board2
3. Plug the wireless heart rate cable into the wireless heart rate board.
Install back cover
Install the four screws securing the back cover to the console assembly using a Phillips screwdriver.
Page 217 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
