4. Carefully lift handset assembly and unplug the following cables: graphics board (J12), handset
membrane (J9), contact heart rate grips (J7) and the ground wire (located under the MCC board).
Qty.DescriptionItem
1MCC board1
1Graphics board (J12)2
1Handset membrane (J9)3
1Contact heart rate grips (J7)4
Remove iPod Cable
The iPod cable is held in place by a notch in the access cover. The access cover is connected to the
handset and was removed in the previous procedure.
Qty.DescriptionItem
1iPod Cable1
1
Access Cover (Shown for
reference)
2
1MCC Board3
1Connector4
5Notch5
Unplug the iPod cable from the connector in the MCC board.
Install iPod Cable
Plug the iPod cable into the connector in the MCC board.
Ensure the iPod cable is routed through the notch in the access cover when installing the handset.
Page 237 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
