Remove heart rate grips
1. Remove two screws from each bottom grip using a Phillips screwdriver.
Qty.DescriptionItem
2Top grip1
2Bottom grip2
1Handset3
4Screw4
2Heart rate wire top (Red)5
2
Heart rate wire bottom
(Black)
6
2. Gently pull top and bottom grip off of handset.
3. Carefully disconnect heart rate wire from each grip using needle nose pliers.
4. Remove heart rate wires from handset. Note the wire locations and colors.
5. Clean inside and outside surfaces of top and bottom grips with rubbing alcohol. Wipe dry.
Install heart rate grips
1. Install heart rate wires into handset with correct location and color.
2. Carefully connect heart rate wire to each grip using needle nose pliers.
Ensure that red heart rate wire is connected to top grip and black heart rate wire is connected to
bottom grip.
Qty.DescriptionItem
2Top grip1
2Bottom grip2
1Handset3
4Screw4
2Heart rate wire top (Red)5
2
Heart rate wire bottom
(Black)
6
3. Place top and bottom grip in correct position on handrail.
Do not pinch heart rate wires during assembly.
4. Install two screws securing each heart rate grip using a Phillips screwdriver.
Page 241 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
