CYBEX 770T - Page 245

Remove MCC board
1. Carefully unplug the following cables from the MCC board; display (J16), console (J15), CSAFE
(J18) and gray audio (J14).
NOTE: Depending on the configuration, some cables may not be present.
Qty.DescriptionItem
1Display (J16)1
1Console (J15)2
1Wing Nut3
1Ground Connector4
1CSAFE (J18)5
1Audio, gray (J14) Optional6
2. Remove the four screws securing the MCC board to the console using a Phillips screwdriver.
Set the screws aside.
Qty.DescriptionItem
1MCC Board1
4Screw2
1Console3
3. Remove the MCC board from the console by pulling the MCC board off of the ground connector
near the wing nut.
Install MCC board
1. Install the MCC board into the console by plugging into the ground connector.
Page 245 of 261
Cybex 770T/790T Treadmill Part Number