EasyManua.ls Logo

Cyclamatic Power Plus CX1 - Key Safety Safeguards; Personal Safety Guidelines; Electrical Safety Precautions

Cyclamatic Power Plus CX1
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Important Safeguards:
Personal Safety:
• This eBike is intended for use as a commuter and
leisure bicycle. Using the eBike for any other purpose
may result in serious injury.
• Before you ride this eBike, take time to learn the
eBike’s controls and power.
• It is your responsibility to identify and follow all
local laws.
• Observe the applicable traffic regulations.
• At night your eBike MUST have white front and red
rear lights.
• Always ride with both hands on the bar.
• Adopt a speed that reflects the terrain as well as
your riding ability.
• Use designated cycle paths when not using public
roads.
• Avoid loose clothing as it can get between moving
parts and cause injury.
• Reflective clothing is recommended.
• Always wear a bike helmet.
• Take care when loading your eBike into a car or
when mounting it on a bicycle carrier.
• We advise that bike trailers not to be used with the
eBike.
Electrical Safety:
• Only use batteries and chargers supplied.
• Don’t modify the charger in any way.
• The charger has been designed for a specific voltage,
always check that the mains voltage is the same as that
stated on the rating label.
• Never use the charger with another appliance or
attempt to charge this product with another charger.
• Before use, check the charger cord for signs of
damage or aging. A damaged or entangled charger
cord increases the risk of fire and electric shock.
• Do not pull the cord to disconnect from a socket;
grasp the plug and pull to disconnect.
• Don’t wrap the cord around the charger when
storing.
• Keep the charger cord away from hot surfaces and
sharp edges.
• Do not handle the charger with wet hands.
• Do not store or charge the appliance outdoors.
• The charger must be removed from the socket
before removing the battery.