Need help?Do you have a question about the CycleOps XDR and is the answer not in the manual?
General| Brand | CycleOps |
|---|---|
| Model | XDR |
| Category | Fitness Equipment |
| Language | English |
Remove the drive side endcap by inserting a 5mm Allen key and turning counter-clockwise.
Slide the freehub off the axle; the wave washer and top hat spacer may come off with it.
Ensure the wave washer is pressed outside the innermost channel before installing a new freehub.
Slide the Top Hat Spacer onto the axle, followed by the XDR Driver.
Install end caps on the axle that match your rear drop out configuration.
For XD cassettes, leave the spacer installed. For XDR cassettes, remove the spacer.
Access full warranty details and information online at www.cycleops.com/support/warranty.
To Next Page
