Cygnus 3 Operating Manual
An information message is first
displayed to alert the user that
the velocity values should only
be used as a general guide.
You must press the ACCEPT key
Use the arrow key to select the
required material then press the
OK key to exit.
You will be asked to confirm
your selection.
Customising the Velocity Table
The velocity table gets its names and values from a file on the
internal memory card in the gauge. You can modify this file to add,
remove or edit the velocity table contents as required.
To view the velocity table file first connect the gauge to a
computer using the USB cable. Locate the file on the gauge called
‘vtable.txt’, you can open it with Notepad.
To Next Page
Loading...