Cygnus 3 Operating Manual
M4-CYG3-M-ENG_Iss2.doc
56
The new Grid Point record file is
The gauge is now ready to start
logging thickness measurement
results
Note the middle function key
name is now LOG – this key is
used to log the thickness
measurements that have been
logged is shown on the right of
the screen followed by the total
number required in your grid.
The name of the current
measurement point is shown on
To log the displayed thickness
measurement press the LOG key
The gauge will give a BEEP and
the display will inverse. When
the data has been saved the
The gauge is now waiting for the
next thickness measurement
The name of the current
measurement point has moved
to the next grid point location
To Next Page
Loading...