CYP AU-A300-HBT - Telnet and RS-232 Command Interface

9
9
7.2 Telnet & RS-232 Command
Command Description Parameter
?
DISPLAY LIST OF
COMMANDS, CODE
ENTRY IS CASE SENSITIVE
HELP
DISPLAY LIST OF
COMMANDS, CODE
ENTRY IS CASE SENSITIVE
PWR POWER CONTROL 0:OFF 1:ON
SOURCE AUDIO IN SELECT
S:STATUS 0:LINE IN 1:RCA
IN 2:OPT. 3:COAX.
4:eAUDIO 5:HDMI
6:HDBaseT
VOL OUTPUT VOLUME SETTING
S:SHOWVOL +:+0.5dB
++:+2dB -:-0.5dB --:-2dB or
0~-80dB
MUTE
OUTPUT VOLUME MUTE
CONTROL.
S:STATUS 0:UN-MUTE
1:MUTE
HDMI HDMI OUT SOURCE SELECT
S:STATUS 0:HDMI
1:HDBASET
HDBASET
HDBASET OUT SOURCE
SELECT
S:STATUS 0:HDMI
1:HDBASET
EDID EDID MODE SELECT
S:STATUS 0:INT 1:EXT
2:HDBaseT 3:HDMI
FADEFAULT
FACTORY DEFAULT
SETTING
REBOOT REBOOT THE UNIT
SIPMODE SET THE IP MODE 0:STATIC IP 1:DHCP
IPCONFIG
PRINT THE IP
CONFIGURATION TO THE
SCREEN
SHOWMAC
PRINT THE MAC ADDRESS
TO THE SCREEN