CYP PU-507RX-SCD - Page 12

12
COMMAND DESCRIPTION
S SATURATION 0~60 Sets the numerical value for the
SATURATION setting (0~60)
R SATURATION Reports the numerical value for the
SATURATION setting (0~60)
S SHARPNESS 0~30 Sets the numerical value for the
SHARPNESS setting (0~30)
R SHARPNESS Reports the numerical value for the
SHARPNESS setting (0~30)
S NR 0~3 0=OFF 2=MIDDLE
1=LOW 3=HIGH
R NR Reports the numerical equivalent for the
NOISE REDUCTION setting (as listed above)
S AUDIO DELAY 0~3 0=OFF 2=110ms
1=40ms 3=150ms
R AUDIO DELAY Reports the numeric equivalent for AUDIO
DELAY setting (as listed above)
S AUDIO MUTE 0/1 0=ON 1=MUTE
R AUDIO MUTE Reports the numeric equivalent for AUDIO
MUTE setting (as listed above)
S KEY LOCK 0/1 0=ENABLE 1=DISABLE
R KEY LOCK Reports the numeric equivalent for KEY
LOCK setting (as listed above)
FW Checks the FIRMWARE version
S RESET 1 Sets the numerical equivalent for the RESET
setting (as left)
Note:
1. RS-232 commands will not execute unless followed with carriage return
and LF (Line Feed).
2. Commands are case-insensitive.
3. Resolutions 1~16 are RGB encoded and 17~25 are YUV encoded.
4. Digital audio supports LPCM 2CH only, please ensure the source input audio
is set to send LPCM 2CH audio in order to avoid unwanted audio noise.