13
6.4 Remote Control
1
POWER: Press to power the unit on or place it
into stand-by mode.
2
LOCK: Press to lock/unlock the front panel of
the matrix unit.
3
MUTE: Mutes Zone Audio outputs. HDBaseT
audio can only be muted when an independent,
non-HDMI, audio source has been routed to the
output.
4
IN 1~6, OUT A~H & PATTERN:
[Local matrix control]: When controlling the
unit directly. Input selection from 1~6 plus test
patterns (pattern button) and output selection
from A~H (refer to section 6.1).
[Zone A/V Pairing]: When controlling the unit
via an HDBaseT receiver in a remote location.
Pressing buttons 1~10 will switch to the A/
V source assigned to the number depending
on your current zone. These assignments are
congured via the WebGUI (refer to section 6.10.6).
5
MENU/CANCEL: Press the “MENU/CANCEL” button to enter the OLED
menu, or to back out from menu items.
6
PRESET: Recall matrix presets. The presets are congured within the
WebGUI.
7
+/IN: Within the menu, this button moves you up within the menu
tree. Otherwise, in routing mode, this button allows you to make your
input source selection.
-/OUT: Within the menu, this button moves you down within the
menu tree. Otherwise, this button starts routing mode and allows you
to begin your output destination selections.
◄
/VOL- &
►
/VOL-: Adjust volume of zone audio.
ENTER: Press this button to conrm selections.
Note: This remote control is designed for the full family of matrix products.
Some functions are not available on all units.
POWERLOCKMUTE
1/A 2/B 3/C
4/D 5/E 6/F
7/G 8/H 9/I
10/J PATTERN
+/IN
MENU/
CANCEL
PRESET
/VOL+
/VOL-
CR-163
ENTER
-/OUT
1
2
4
3
5
7
6
To Next Page
Loading...