CYP PUV-1210PL-RX - Page 23

23
COMMAND DESCRIPTION
ZoneLineOut M Bass=XXX Set the bass value for a zone line
output.
M = A~F
XXX = -12~+12 (units: dB)
ZoneLineOut M Volume=XXX Set the volume for a zone line
output.
M = A~F
XXX = 0 ~ -100 (units: dB)
ZoneLineOut M Volume=Fast XXX Adjust the volume of a zone line
output in large steps (2dB steps).
M = A~F
XXX = “Up” or “Down”
ZoneLineOut M Volume=Slow XXX Adjust the volume of a zone line
output in small steps (0.5dB steps).
M = A~F
XXX = “Up” or “Down”
ZoneLineOut M Delay=XXX Set the audio delay for a zone line
output.
M = A~F
XXX = 0~230 (units: ms)
ZoneLineOut M Mute Mute a zone line output.
M = A~F
ZoneLineOut M Unmute Unmute a zone line output.
M = A~F
ZoneLineOut M Status Display the status of a zone line
output.
M = A~F