CYP PUV-1210PL-RX - Page 24

24
COMMAND DESCRIPTION
ZoneLineOut M Name={NameString} Set the verbose name of a zone line
output. Maximum 32 characters.
M = A~F
Note: Can only rename one port at
a time. Multi-port is not supported.
ExtLineOut M AudioSrc=XXX Set the audio source for an
extended line output.
M = 1~2
Available XXX values:
HDMI_In n [n = 1~6]
OpticIn n [n = 1]
CoaxIn n [n = 1]
AnalogIn n [n = 1~2]
OAR_In n [n = A~F]
ExtLineOut M Treble=XXX Set the treble value for an
extended line output.
M = 1~2
XXX = -12~+12 (units: dB)
ExtLineOut M Bass=XXX Set the bass value for an extended
line output.
M = 1~2
XXX = -12~+12 (units: dB)
ExtLineOut M Volume=XXX Set the volume for an extended
line output.
M = 1~2
XXX = 0 ~ -100 (units: dB)