page 18 - Smoke Jumper CYPRES 2 User’s Guide -
8. Installation
The original smoke jumper harness and container
was investigated by Airtec a number of years ago.
The positioning of all components was dened
and tested.
The new smoke jumper harness and container,
designed by the Relative Workshop in the end of
2003 was also investigated by Airtec. The posi-
tioning of all components was dened in coopera-
tion with the Relative Workshop and tested.
Under no conditions are deviations from these in-
structions allowed.
Control unit cable and cutter cable must be placed
without tension. Excess cable is stowed in the at
part of the pocket underneath the velcro-adjust-
able ap. If you have to stow both the thinner cut-
ter cable and the thicker control unit cable, be sure
to place the thicker cable so that it lays on top of
the thinner one. Cables should be placed in a cir-
cle in order to avoid twists. Always avoid pulling,
bending, twisting or kinking the cables.
right
wrong
To Next Page
Loading...