Let's Explore
A servo motor uses a three-wire
system for power (+), ground (-) and
signal. Here's how you are to connect
it to the micro:bit
Pin-0 (P0), Pin-1 (P1) or Pin-2 (P2)
- Which pin is it connected to?
0 to 180 - The angle you
want the servo to turn to.
When it is connected to the micro:bit,
you can control the motor rotation to
a specic angle, between the range of
0 to 180 degrees using
[ servo write pin __ to __ ] block from
the [ Advanced - Pins ] category.
19
Brown
Ground Power Signal
Red
Red
Orange
White
Black
Pin-GND
Pin-0,1 or 2
Pin-3V
To Next Page