8
3.2.2 Folding your Dragony
To fold the Dragony:
1. First, open the tiller offset.
This is very important as it
protects the dashboard from
coming into contact with the
rear wheels. Keep one hand at
the top of the tiller, preferably
on the handlebar.
2. While steadying the tiller,
use your opposite hand to lift
the safety catch on the folding
mechanism and pull down the
lower latch.
3. Slowly and carefully fold the
handlebars and tiller towards
the deck.
4. Carefully stand up your
Dragony, under the screen
you will see a small bungee
cord. Stretch each bungee
around the rod ends as per
the image and pull tight.
3.2.3 Inating Your Tires
For safety reasons, when you rst receive your Dragony, your tires will not be
pressurized.
Before riding, you must put pressure in your tires. Follow these instructions to inate
your tires:
1. Remove the dust cap on each valve found on the outer edge of
your tires.
2. In your toolkit, there is a valve extender. Find this tool.
3. Screw the valve extender on to the tire valve, and plug the other
end of the extender to a bike pump (or any similar pump, foot pump,
electric pump etc).
4. Now, pump 50PSI (3.44738 bar) of pressure into each tire. Do not
exceed 50PSI. Once all tires are inated, you are set to learn how to
use your Dragony.
5. Each bungee end can now
be clipped into the small hook.
You will feel a slight snap when
it’s clipped into place.
6. Press the small button on
the hook and to tighten if
needed.
To Next Page
Loading...
