D Light Aura - Treatment Procedures; How to Prepare Treatments; Select Energy Level; Epilation Treatment

10 - GB GB - 11
ENGLISH ENGLISH
Do not use the appliance on naturally dark
complexion or on tanned skin!
HOW TO PREPARE THE TREATMENTS
Before starting treatments, prepare the treatment area by thoroughly cleaning the skin and remove
makeup. Hair must be shaved with a razor or a hair clipper, it is preferable to use a clipper as you
immediately obtain an optimal length of 1mm, and maximizes the absorption of pulsed light (in
epilation treatment), using the clipper will also avoid any skin irritation.
Given that the pulsed light is absorbed by dark colors, it is necessary to protect small, dark
birthmarks and tattoos, cover it with white eyepencil makeup, or with a specic product like the D
Light Patch Pro.
Do not let the pulsed light pass on large or irregular areas! In
the presence of doubt, ask your dermatologist before initiating
treatments!
Do not use the pulsed light on varicose veins and any type of skin
lesions
It is always advisable to begin at the lowest energy level and gradually increase to nd the right
intensity according to your own tolerance. The energy level is selected by repeatedly pressing the
energy button (10) after the machine has been started.
As the enegry level increases, so does the results, as well as the risk of possible side e󰀨ects.
SELECT ENERGY LEVEL
If blistering occurs on the skin, or if you feel burning,
IMMEDIATELY STOP using the device.
EPILATION TREATMENT
The D Light Aura epilation treatment is suitable for all body areas that have hair except the scalp,
male beard, eyebrows, genital and perianal areas.
Any birthmarks or tattoos on the area to be treated must be covered before starting the treatment,
to protect them, you can use an opaque white makeup pencil or a specic product like the D light
Patch Pro. Before starting the treatment, it is advisable to wear certied laser safety glasses or
pulsed light safety eyewear, as an alternative, you can close your eyes when the ash is emitted.
Dene the area to be treated (can also help by drawing a grid with a white makeup pencil) and
select the appropriate energy level of the skin type when you are ready.
It is always advisable to start at the lowest energy level and depending on your tolerance, if
you experience no discomfort, you can increase the energy level, treatment is more e󰀨ective
at highest energy level, but the ash takes longer to load. You can choose between two modes
of operation: single ash or scroll. Using the single ash mode, a ash is emitted everytime the
Flash button (2) is pressed. The scroll mode is activated by holding the Flash button (2) down for
3 seconds, then you can release it and the device will emit ash repeatedly whenever the Flash
window will come into contact with the skin. To turn o󰀨 scroll mode, just press the Flash button (2)
once and the appliance resumes to function on single ash mode.
When the Flash window is correctly in contact with the skin and the machine is ready for the
Flash, the display starts ashing. It is recommended to radiate 1, maximum 2 times on each
treated area then proceed and move to the next area.
EPILATION TREATMENT CYCLE
For the rst 3 months, it is advisable to proceed with 1 treatment per week or every 2 weeks if
you are also doing IPL photorejuvenation or acne treatments on the same area, it is important to
spend at least one week between other treatments by alternating Epilation to the others. The skin
should be hairless after nishing the rst 3 month cycle, therefore there will only be maintenance
sessions needed when the hairs begin to reappear (usually a session every 2 or 3 months,
depends on the of individual growth rhythm).