Tools > Admin
New Password: Enter the
new password.
Confirm Password:
Re-enter the password to
confirm it.
Tools > System
Save Settings: The current
system settings can be saved
as a file onto the local hard
drive.
Load Settings: The saved
file or any other saved setting
file can be loaded back on the
access point. To reload a system
settings file, click on Browse
to browse the local hard drive
and locate the system file to
be used. Click Load when you
have selected the file to be
loaded back onto the access
point.
Restore: You may also reset the DWL-G730AP back to
factory settings by clicking on Restore. Make sure to save the unit’s settings before
clicking on Restore. You will lose your current settings when you click Restore.
Using the Configuration Utility in AP Mode (continued)
To Next Page
Loading...
