D-Link DES-1210-28/ME - Config Gvrp

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
161
[tagged | untagged | forbidden] | delete ] <portlist>
{advertisement [enable | disable]}
Description
The config vlan command allows the user to add or delete ports to
the port list of a previously configured VLAN. You can specify the
additional ports as tagging, untagging, or forbidden. The default is to
assign the ports as untagged.
Parameters
<vlan_name 20> − The name of the VLAN to be configure.
vlanid <vlan_id 1-4094 > − The ID of the VLAN to which to add
ports.
add − Specifies that ports are to be added to a previously created
vlan.
delete - Specifies that ports are to be deleted from a previously
created vlan.
tagged − Specifies the additional ports as tagged.
untagged − Specifies the additional ports as untagged.
forbidden − Specifies the additional ports as forbidden.
<portlist> − A port or range of ports to be added to or deleted from
the VLAN.
advertisement [enable | disable] − Specifies that the vlan
advertisement is enabled or disabled.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To add ports 4 through 8 as tagged ports to the VLAN 3:
DES-1210-28/ME:5# config vlan vlanid 3 add tagged 4-8
Command: config vlan vlanid 3 add tagged 4-8
Success
DES-1210-28/ME:5#
config gvrp
Purpose To configure configures the Group VLAN Registration Protocol on
the Switch. The user can configure ingress checking and acceptable
frame tagged only, the sending and receiving of GVRP information,
and the Port VLAN ID (PVID).
Syntax
config gvrp [<portlist> | all] state [enable | disable]
{ ingress_checking [enable | disable] | acceptable_frame
[Tagged_Only | All_Frames] | pvid <vlanid 1-4094>}
Description
The config gvrp command configures the Group VLAN Registration
Protocol on the Switch. The user can configure ingress checking and
acceptable frame tagged only, the sending and receiving of GVRP
information, and the Port VLAN ID (PVID).
Parameters
<portlist> − A port or range of ports for which to configure GVRP.
all − configure GVRP on ports.
state [enable | disable] - enable and disable GVRP
ingress_checking [enable | disable] − Enables or disables ingress
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – Defines the type of
frame accepted. Acceptable frames can be limited to tagged frames
only (tagged_only) or can accept tagged and untagged (admit_all).