D-Link DES-1210-52/ME - Config Traffic Control Auto_Recover_Time; Show Traffic Control

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
176
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To configure traffic control and enable broadcast storm control system wide:
DES-1210-52/ME:5# config traffic control all multicast enable unicast disable
broadcast enable threshold 64
Command: config traffic control all multicast enable unicast disable broadcast e
nable threshold 64
*Note: Setting count down for drop mode port was ignored.
Success.
DES-1210-52/ME:5#
config traffic control auto_recover_time
Purpose
To configure the traffic auto recover time that allowed for a port to
recover from shutdown forever status.
Syntax
config traffic control auto_recover_time [0 | <min 1-65535>]
Description
The config traffic control auto_recover_time command
configures.
Parameters
[0 | <min 1-65535>] – Specifies the automatic recovery time to be
used. The value must be between 1 and 65535 minutes. 0 means
‘no recovery mode’.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To configure the auto recover time to 100:
DES-1210-52/ME:5# config traffic control auto_recover_time 100
Command: config traffic control auto_recover_time 100
Success.
DES-1210-52/ME:5#
show traffic control
Purpose
To display current traffic control settings.
Syntax
show traffic control {<portlist>}
Description
The show traffic control command displays the current storm traffic
control configuration on the Switch.
Parameters
<portlist> - A port or range of ports whose settings are to be
displayed.
Restrictions
None.
Example usage:
To display traffic control setting for ports 1-3:
DES-1210-52/ME:5# show traffic control 1-3