D-Link DES-1210-52/ME - Basic Switch Commands

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
8
4
BASIC SWITCH COMMANDS
The Basic Switch commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
enable password
encryption
disable password
encryption
create account
[admin | operator | power-user | user] <username 15>
config account
<username 15>
show account
delete account
<username 15>
show session
show switch
enable jumbo_frame
disable jumbo_frame
show jumbo_frame
enable clipaging
disable clipaging
enable web
{<tcp_port_number 1-65535>}
disable web
enable autoconfig
disable autoconfig
save
{[config config_id <value 1-2> | log]}
reload config
config_id <value 1-2>
reboot
reset
{[config | system | account | password | cpu]} {force_agree}
logout
ping
<ipaddr> {times <value 1-255> | timeout <sec 1-99> | size <short 0-2080>}
ping6
<ipv6_addr> {frequency <sec 0-86400> | size <value 1-1522> | source_ip
<ipv6_addr> | timeout <sec 1-99> | times <value 1-255>}
enable telnet
disable telnet
config time_range
<range_name 20> [[hours start_time <start_time 32> end_time <end_time 32>