D-Link DES-1210-52/ME - Mac Notification Commands; Enable Mac_Notification; Disable Mac_Notification

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
253
34
MAC NOTIFICATION COMMANDS
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
enable
mac_notification
disable
mac_notification
config mac_notification
[interval <int 1-2147483647> | historysize <int 1-500>]
config mac_notification
ports
[<portlist> | all] [enable | disable]
show mac_notification
show mac_notification
ports
{<portlist>}
Each command is listed in detail, as follows:
enable mac_notification
Purpose
Used to enable global MAC address table notification on the Switch.
Syntax
enable mac_notification
Description
The enable mac_notification command is used to enable MAC
address notification without changing configuration.
Parameters
None.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To enable MAC notification without changing basic configuration:
DES-1210-52/ME:5# enable mac_notification
Command: enable mac_notification
Success.
DES-1210-52/ME:5#
disable mac_notification
Purpose
Used to disable global MAC address table notification on the Switch.
Syntax
disable mac_notification
Description
The disable mac_notification command is used to disable MAC