D-Link DES-1210-52/ME - Igmp Snooping Commands

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
257
35
IGMP SNOOPING COMMANDS
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
config igmp_snooping
[vlan_name <string 32> | vlanid <vidlist> | all] [host_timeout <sec 130-153025> |
router_timeout <sec 60-600> | leave_timer <sec 1-25> | fast_leave [enable |
disable] | state [enable | disable]]
config igmp_snooping
querier
[vlan_name <string 32> | vlanid <vidlist> | all] state [enable | disable]
{querier_version [2 | 3] | last_member_query_interval <sec 1-25> |
query_interval <sec 60-600> | robustness_variable <value 2-255> |
max_response_time <sec 10-25>}
create igmp_snooping
multicast_vlan
<vlan_name 32> <vlanid 2-4094>
config igmp_snooping
multicast_vlan
<vlan_name 32> [add | delete] [member_port <portlist> | source_port <portlist> |
tag_member_port <portlist>] state [enable | disable] {replace_source_ip [none |
<ipaddr>]}
delete igmp_snooping
multicast_vlan
[all | <vlan_name 32>]
config igmp_snooping
multicast_vlan_group
<vlan_name 32> [add | delete] ipv4_range <ipaddr> <ipaddr>
create igmp_snooping
static_group
[vlan <vlan_name 32> | vlanid <vlanid_list>] <ipaddr>
config igmp_snooping
static_group
[vlan <vlan_name 32> | vlanid <vlanid_list>] <ipaddr> [add | delete] <portlist>
delete igmp_snooping
static_group
[vlan <vlan_name 32> | vlanid <vlanid_list>] <ipaddr>
show igmp_snooping
static_group
{vlan <vlan_name 32> | vlanid <vlanid_list> | <ipaddr>}
config igmp_snooping
data_driven_learning
[all | vlan_name <string 32> | vlanid <vidlist>] {state [enable | disable]
expiry_time <sec 130-153025> aged_out}
config igmp_snooping
data_driven_learning
max_learned_entry <integer 1-256>
clear igmp_snooping
data_driven_group
[all | vlan_name <vlan_name 32> | vlanid < vidlist >] [all | MCGroupAddr
<ipaddr>]
config igmp_snooping
max_response_time
<integer 10-25>
config router_ports
[vlan_name <string 32> | vlanid <vidlist> | all] [add | delete] <portlist>
config router_port
s_forbidden
[vlan_name <string 32> | vlanid <vidlist> | all] [add | delete] <portlist>
config igmp
access_authentication
[<portlist> | all] state [enable | disable]