D-Link DES-1210-52/ME - Routing Table Commands; Create Iproute

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
331
44
ROUTING TABLE COMMANDS
The Routing table commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
create iproute
default <ipaddr> {<value 1-254>}
delete iproute
{default}
show iproute
{<ipaddr> | static}
Each command is listed in detail, as follows:
create iproute
Purpose
Used to create IP route entries to the Switch’s IP routing table.
Syntax
create iproute default <ipaddr> {<value 1-254>}
Description
The create iproute command is used to create a default static IP
route entry to the Switch’s IP routing table.
Parameters
default – Specifies to create a default IP route entry.
<ipaddr> − The gateway IP address for the next hop router.
<value 1-254> − Allows the entry of a routing protocol metric entry,
representing the number of routers between the Switch and the IP
address above. The default setting is 1.
Restrictions
Only Administrator, operator and power user-level users can issue
this command.
Example usage:
To add the default static address 10.90.90.92 to the routing table:
DES-1210-52/ME:5# create iproute default 10.90.90.92
Command: create iproute default 10.90.90.92
Success.
DES-1210-52/ME:5#