D-Link DES-1210-52/ME - Show Lldp Power_Pse_Tlv

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
391
To configure LLDP mac_phy_configuration status:
DES-1210-52/ME:5# config lldp ports all dot1_tlv_vlan_name vlanid 1 disable
Command: config lldp ports all dot1_tlv_vlan_name vlanid 1 disable
Success.
DES-1210-52/ME:5#
config lldp ports
Purpose
To enable or disable LLDP management LLDP power pse TLVs
advertisement on a port or ports.
Syntax
config lldp ports [<portlist>|all] power_pse_tlv [enable | disable]
Description
The config lldp ports dot1 TLVs command enable or disable the LLDP
power pse TLVs per port on the switch.
Parameters
[<portlist> | all] – Specify a port or ports to be configured.
[enable | disable] – Specify the LLDP power pse TLVS to be enable or disable
for the specified port.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable LLDP power pse TLVs for port 3-5:
DES-1210-52/ME:5# config lldp ports 3-5 power_pse_tlv enable
Command: config lldp ports 3-5 power_pse_tlv enable
Success.
DES-1210-52/ME:5#
show lldp power_pse_tlv
Purpose
To display the Link Layer Discovery Protocol (LLDP) power pse
TLVs information.
Syntax
show lldp power_pse_tlv
Description
The show lldp power_pse_tlv command displays the information of
power pse TLVs.
Parameters
None.
Restrictions
None.
Example usage:
To show the LLDP power pse TLVs: