<macaddr> | 802.1p <value (0-7)> | ethernet_type <hex (0x0-
0xffff)>} | ip {source_ip <ipaddr> | destination_ip <ipaddr> |
dscp <value (0-63)> | [icmp {type <value (0-255)> code <value
(0-255)> } | igmp {type <value (0-255)>} | tcp {src_port <value (0-
65535)> | dst_port <value (0-65535)> | urg | ack | psh | rst | syn |
fin} | udp {src_port <value (0-65535)> | dst_port <value (0-
65535)> | protocol_id <value(0-255)>] | ipv6 {class | source_ipv6
<ipv6addr> | destination
_ipv6 <ipv6addr>}
[port [<portlist> | all]
[permit | deny]] delete access_id <value (1-5)>]
profile_id <value 1-3> – Specifies the cpu access profile to be
configured.
[add | delete] – Add or delete the profile id.
access_id [<value 1-5> | auto_assign] – Specifies the access id
value or use auto assign.
ethernet – Specifies that the Switch examine only the layer 2 part of
each packet to determine if it is to be filtered or forwarded based on
one or more of the following:
802.1p <value 0-7> – Specifies the 802.1p value. The range
is between 0 and 7.
destination_mac <macaddrf> – Specifies the destination
MAC address.
ethernet_type – Specifies the Ethernet type mask.
<portlist> – Specifies the port or ports to be configured.
source_mac <macaddr> – Specifies the source MAC
address.
vlan <vlanid 1-4094> – Specifies the VLAN id.
ip – Specifies that the Switch examine the IP fields in each packet to
determine if it will be either forwarded or filtered based on one or
more of the following:
destination_ip <ip_addr> – Specifies the destination IP
address.
dscp <value 0-63> – Specifies the DSCP value.
icmp – Specifies that the Switch examines the Protocol field in
each frame’s IP header , and that the value must be 1 (Internet
Control Message Protocol- ICMP) for the action to take place.
code <value 0-255> –Specifies that the Switch examine
each frame’s ICMP code field.
type <value 0-255> –Specifies that the Switch examine each
frame’s ICMP Type field.
igmp – Specifies that the Switch examine each frame’s protocol
field and it must be 2 (Internet Group Management Protocol-
IGMP) for the action to take place.
igmp_type <value 0-255> – Specifies the IGMP type.
<portlist> – Specifies the port or ports to be configured.
protocol_id <value 0-255> – Specifies the protocol id.
source_ip <ip_addr> –Specifies that the cpu access profile applies
only to packets with this source IP address.
Tcp – Specifies that the Switch examines each frames protocol
field and its value must be 6 (Transmission Control Protocol-
TCP) for the action to take place
dst_port <value 0-65535> –Specifies that the cpu access
To Next Page
Loading...
