DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
405
profile applies only to packets that have this TCP destination
port in their header.
flag <string> – Specifies the appropriate flag parameter.
src_port <value 0-65535> –Specifies that the cpu access
profile applies only to packets that have this TCP source
port in their header.
udp – Specifies that the Switch examines each frame’s protocol
field and it’s value must be 17 (User Datagram Protocol-UDP) in
order for the action to take place.
dst_port <value 0-65535> – Specifies that the CPU access
profile applies only to packets that have this UDP
destination port in their header.
src_port <value 0-65535> – Specifies that the CPU access profile
applies only to packets that have this UDP source port in their
header.
ipv6 - Specifies that the Switch examines the IPv6 fields in each
packet with special emphasis on one or more of the following:
class – Examine the class field of the IPv6 header.
source_ipv6 <ipv6addr> – Specifies the source IPv6
address.
destination_ipv6 < ipv6addr > – Specifies the destination
IPv6 address.
Only administrator or operate-level users can issue this command.
Example usage:
To configure a rule for the CPU IP access profile:
DES-1210-52/ME:5# config cpu access_profile profile_id 2 add access_id
auto_assignip destination_ip 10.48.100.2 ports 1-3 permit
Command: config cpu access_profile profile_id 2 add access_id auto_assign
ip destination_ip 10.48.100.2 ports 1-3 permit
Success.
DES-1210-52/ME:5#
delete cpu_access_profile
To delete a previously created cpu access profile.
delete cpu_access_profile profile_id <value 1-3>
The delete cpu_access_profile command deletes a previously
created access profile on the Switch.
profile_id <value 1-3> – Specifies the cpu access profile to be
deleted.
Only administrator or operate-level users can issue this command.
Example usage:
To delete the CPU access profile with a profile ID of 1:
To Next Page
Loading...
