DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
407
To view the CPU access profile entry currently set in the Switch.
show cpu_access_profile {profile_id <value 1-3>}
The show cpu access_profile command is used view the current
CPU interface filtering entries set on the Switch.
profile_id <value 1-3> – Enter an integer between 1 and 3 that is
used to identify the CPU access profile to be deleted with this
command. This value is assigned to the access profile when it is
created with the create cpu access_profile command.
Example usage:
To show the CPU filtering state on the Switch:
DES-1210-52/ME:5# show cpu_access_profile
Command: show cpu_access_profile
Access Profile Table
Access Profile ID: 1 Type: Ethernet
---------------------------------------------------------------------------
---------------------------------------------------------------------------
Mask Option:
VLAN
--------------------------------------------------------------------------
DES-1210-52/ME:5#
config flow_meter profile_id
To configure the flow-based metering function on the Switch.
config flow_meter profile_id <value 1-10> access_id <value 1-
128> [delete | rate <value 64-1024000>] burst_size <value 0-
1016> rate_exceed [drop_packet | remark_dscp <value 0-63>]
The config flow_meter profile_id command configures the flow-
based metering function on the Switch.
profile_id <value 1-10> - .Specify the profile id to be configured.
access_id <value 1-128> - Specify the access id to be configured.
rate <value 64-1024000> - Specifies the committed bandwidth in
Kbps for the flow.
burst_size <value 0-1016> - Specifies the burst size
rate_exceed: pecifies the action for packets that exceeds the
committed rate in single rate
drop_packet - Drop the packet immediately.
remark_dscp <value 0-63> - Specify the remark DSCP value.
Only administrator or operate-level users can issue this command.
Example usage:
To config flow meter information:
To Next Page
Loading...
