DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
30
The disable telnet command disables telnet.
Only Administrator or operate-level users can issue this command.
Example usage:
To disable telnet:
DES-1210-52/ME:5# disable telnet
Command: disable telnet
Success.
DES-1210-52/ME:5#
To telnet another device.
telnet <ipaddr> {-l <string>}
The telnet command is used to telnet another device.
Only Administrator or operate-level users can issue this command.
Example usage:
To telnet another device which IP is 10.90.90.91:
DES-1210-52/ME:5# telnet 10.90.90.91
Command: telnet 10.90.90.91
To configure the time range on the Switch.
config time_range <range_name 20> [[hours start_time
<start_time 32> end_time <end_time 32> weekdays <daylist 32>
date from_day year <start_year 2011-2029> month <start_mth 1-
12> date <start_date 1-31> to_day year <end_year 2011-2029>
month <end_mth 1-12> date <end_date 1-31>] | delete]
The config time_range command defines time ranges for access
lists. If the end time is earlier than the start time, the end time will
move to the following day
<range_name 20> – Specifies the time range name. The range of
characters is 1 - 20.
start_time <start_time 32> – defines the time on which the time
range will start to be active.
To Next Page
Loading...
