DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
34
5
DHCP AUTOIMAGE COMMANDS
The DHCP Autoimage commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Each command is listed in detail, as follows:
To enable the DHCP automatic image function on the Switch.
The enable autoimage command is used to enable the DHCP
automatic image function on the Switch.
Only Administrator and Operator-level users can issue this
command.
Example usage:
To enable the DHCP automatic image function on the Switch:
DES-1210-52/ME:5# enable autoimage
Command: enable autoimage
Success.
DES-1210-52/ME:5#
To disable the DHCP automatic image function on the Switch.
The disable autoimage command is used to disable the DHCP
automatic image function on the Switch.
Only Administrator and Operator-level users can issue this
command.
Example usage:
To disable the DHCP automatic image function on the Switch:
To Next Page
Loading...
