D-Link DES-1210-52/ME - Show Address_Binding Auto_Scan List; Enable Address_Binding Dhcp_Snoop; Disable Address_Binding Dhcp_Snoop

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
69
show address_binding auto_scan list
Purpose
Used to display IP-MAC-port binding entries.
Syntax
show address_binding auto_scan list
Description
This show address_binding auto_scan list command is used to
display auto scan list of address binding on the Switch.
Parameters
None.
Restrictions
None.
Example usage:
To display the auto scan list of address binding on the Switch:
DES-1210-52/ME:5# show address_binding auto_scan list
Command: show address_binding auto_scan list
VLAN IP Address MAC Address Port Bound
--------- ------------------ ---------------------- ------ -----------
Total Entries : 0
DES-1210-52/ME:5#
enable address_binding dhcp_snoop
Purpose
Used to enable address binding DHCP Snooping.
Syntax
enable address_binding dhcp_snoop ports [<portlist> | all]
Description
This enable address_binding dhcp_snoop command is used to
enable IP-MAC-port binding DHCP snooping entries.
Parameters
[<portlist> | all] – Specifies a port, a range of ports or all ports to be
enabled of the address binding DHCP snooping on the Switch.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To enable the DHCP snooping of address binding for port 3~5 on the Switch:
DES-1210-52/ME:5# enable address_binding dhcp_snoop ports 3-5
Command: enable address_binding dhcp_snoop ports 3-5
Success.
DES-1210-52/ME:5#
disable address_binding dhcp_snoop
Purpose
Used to disable address binding DHCP Snooping.
Syntax
disable address_binding dhcp_snoop ports [<portlist> | all]
Description
This disable address_binding dhcp_snoop command is used to
disable IP-MAC-port binding DHCP snooping entries.
Parameters
[<portlist> | all] – Specifies a port, a range of ports or all ports to be
enabled of the address binding DHCP snooping on the Switch.