D-Link DES-1210-52/ME - Disable Address_Binding Roaming; Show Address_Binding Roaming; Clear Address_Binding Dhcp_Snoop Binding_Entry Ports

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
73
disable address_binding roaming
Purpose
Used to disable address binding roaming.
Syntax
disable address_binding roaming
Description
This disable address_binding roaming command is used to
disable IP-MAC-port binding roaming.
Parameters
None.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To disable the roaming of address binding on the Switch:
DGS-1210-28/ME:5# disable address_binding roaming
Command: disable address_binding roaming
Success.
DES-1210-52/ME:5#
show address_binding roaming
Purpose
Used to display DHCP snoop of IP-MAC-port binding lroaming
information.
Syntax
show address_binding roaming
Description
This show address_binding roaming command is used to display
DHCP snoop of IP-MAC-port binding roaming information.
Parameters
None.
Restrictions
None.
Example usage:
To display DHCP snoop of address binding roaming information on the Switch:
DGS-1210-28/ME:5# show address_binding roaming
Command: show address_binding roaming
Roaming state is enabled.
DES-1210-52/ME:5#
clear address_binding dhcp_snoop binding_entry ports
Purpose
Used to clear the DHCP snooping entries learned for the specified
ports.
Syntax
clear address_binding dhcp_snoop binding_entry ports
[<portlist> | all] {all | ipv6}
Description
This clear address_binding dhcp_snoop binding_entry ports
command is used to clear the DHCP snooping entries learned for
the specified ports.
Parameters
[<portlist> | all] – Specifies a range of ports or all ports to be
configured.
all - Specifies that all entries will be cleared.
ipv6 - Specifies that IPv6 entries will be cleared.