privileges to administrator privileges, he or she will be prompted to enter the password
configured here that is set locally on the Switch.
Parameters
<password 15> − After entering this command, the user will be prompted to enter the old
password, then a new password in an alphanumeric string of no more than 15 characters,
and finally prompted to enter the new password again for confirmation. See the example
below.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the password for the “local_enable” authentication method.
Command: config admin local_enable
Enter the old password:
Enter the case-sensitive new password:******
Enter the new password again for confirmation:******
Success.
To Next Page
Loading...
