D-Link DES-1228 - Vlan Trunking Commands

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
240
35
VLAN TRUNKING COMMANDS
The VLAN Trunking commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports [<portlist>|all] state [enable|disable]
show vlan_trunk
Each command is listed, in detail, in the following sections.
enable vlan_trunk
Purpose Used to enable the VLAN trunk function.
Syntax
enable vlan_trunk
Description When the VLAN trunk function is enabled, the VLAN trunk ports shall be able to forward all
tagged frames with any VID.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable the VLAN Trunk:
DES-1228/ME:4#enable vlan_trunk
Command: enable vlan_trunk
Success.
DES-1228/ME:4#
disable vlan_trunk
Purpose Used to disable the VLAN trunk function.
Syntax
disable vlan_trunk
Description This command is used to disable the VLAN trunk function.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To disable the VLAN Trunk:
DES-1228/ME:4#disable vlan_trunk
Command: disable vlan_trunk
Success.
DES-1228/ME:4#