D-Link DES-1228 - Page 263

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
258
config lldp dot1_tlv_vlan_name
Parameters
<portlist> − Specified a range of ports to be configured.
all − To set all ports in the system, you may use the “all” parameter.
dot1_tlv_vlan_name − This TLV optional data type indicates whether the corresponding
Local System’s VLAN name instance will be transmitted on the port. If a port is associated
with multiple VLANs those enabled VLAN IDs will be advertised. The default state is
disable.
Restrictions Only Administrator-level users can issue this command.
Example usage
To configure the VLAN name TLV from the outbound LLDP advertisements for all ports:
DES-1228/ME:4# config lldp ports all dot1_tlv_vlan_name vlanid 1-3 enable
Command: config lldp ports all dot1_tlv_vlan_name vlanid 1-3 enable
Success.
DES-1228/ME:4#
config lldp dot1_tlv_protocol_identity
Purpose Used to configure an individual port or group of ports to exclude one or more of IEEE
802.1 organization protocol identity TLV data types from outbound LLDP advertisements.
Syntax
config lldp ports [<portlist>|all] dot1_tlv_ protocol_identity [all | {eapol | lacp | gvrp |
stp }] [enable | disable]
Description This TLV optional data type indicates whether the corresponding Local System's Protocol
Identity instance will be transmitted on the port. The Protocol Identity TLV provides a way
for stations to advertise protocols that are important to the operation of the network. Such
as Spanning Tree Protocol, the Link Aggregation Control Protocol, and numerous vendor
proprietary variations which are responsible for maintaining the topology and connectivity
of the network. If EAPOL, GVRP, STP(including MSTP), and LACP protocol identity is
enabled on this port and it is enabled to be advertised, then this protocol identity will be
advertised.
Parameters
<portlist> − Specified a range of ports to be configured.
all − To set all ports in the system, you may use the “all” parameter.
dot1_tlv_ protocol_identity −
This TLV optional data type indicates whether the
corresponding Local System's Protocol Identity instance will be transmitted on the port.
The Protocol Identity TLV provides a way for stations to advertise protocols that are
important to the operation of the network. Such as Spanning Tree Protocol, the Link
Aggregation Control Protocol, and numerous vendor proprietary variations are responsible
for maintaining the topology and connectivity of the network. If EAPOL, GVRP,
STP(including MSTP), and LACP protocol identity is enabled on this port and it is enabled
to be advertised, then this protocol identity will be advertised. The default state is disable.
Restrictions Only Administrator-level users can issue this command.