44
COMMAND HISTORY LIST
The switch history commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
?
dir
config command_history <value 1-40>
show command_history
enable command logging
disable command logging
show command logging
Each command is listed, in detail, in the following sections.
?
Purpose Used to display all commands in the Command Line Interface (CLI).
Syntax
? {<command>}
Description This command will display all of the commands available through the Command Line
Interface (CLI).
Parameters
{<command>} – Entering the question mark with an appropriate command will list all the
corresponding parameters for the specified command, along with a brief description of the
commands function and similar commands having the same words in the command.
Restrictions None.
To Next Page
Loading...
