D-Link DES-1228 - Page 50

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
45
Example usage:
To create the trusted host:
DES-1228/ME:4#create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
Success.
DES-1228/ME:4#
create trusted_host network
Purpose Used to create the trusted host subnet.
Syntax
create trusted_host network <network_address>
Description The create trusted host network command creates the trusted host subnet. The Switch
allows users to specify up to ten IP network addresses that are allowed to manage the
Switch via in-band SNMP or TELNET based management software. These IP addresses
must be members of the Management VLAN. If no IP addresses are specified, then there
is nothing to prevent any IP address from accessing the Switch, provided the user knows
the Username and Password.
Parameters
<network_address> − The IP address and netmask of the trusted host to be created.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To create the trusted host network:
DES-1228/ME:4#create trusted_host network 10.48.74.121/16
Command: create trusted_host network 10.48.74.121/16
Success.
DES-1228/ME:4#
show trusted_host
Purpose
Used to display a list of trusted hosts entered on the Switch using the create
trusted_host command above.
Syntax
show trusted_host
Description This command is used to display a list of trusted hosts entered on the Switch using the
create trusted_host command above.
Parameters None.
Restrictions Only Administrator-level users can issue this command.