DES-3000 Series Layer 2 Switch CLI Reference Manual
16
config serial_port
Purpose Used to configure the serial port.
Syntax
{baud_rate [9600 | 19200 | 38400 | 115200] |auto_logout [never |
2_minutes | 5_minutes| 10_minutes | 15_minutes]}
Description
This command is used to configure the serial port’s baud rate and auto
logout settings.
Parameters
baud rate [9600 | 19200 | 38400 | 115200] The serial bit rate that will be
used to communicate with the management host.
auto_logout – This parameter will allow the user to choose the time the
Switch’s serial port will be idle before automatically logging out. The user
may choose one of the following.
never No time limit on the length of time the console can be open
with no user input.
2_minutes The console will log out the current user if there is no
user input for 2 minutes.
5_minutes The console will log out the current user if there is no
user input for 5 minutes.
10_minutes The console will log out the current user if there is
no user input for 10 minutes.
15_minutes The console will log out the current user if there is
no user input for 15 minutes.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the baud rate:
DES-3026:4#config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
Success.
DES-3026:4#
To Next Page
Loading...
