DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
To establish the rule for a previously created CPU Access Profile:
In the CPU interface folder, click the CPU Interface Filtering State link to open the CPU Interface Filtering Table.
Figure 9- 6. CPU Interface Filtering Table
In this window, the user may add a rule to a previously created CPU access profile by clicking the corresponding Modify button
of the entry to configure, Ethernet, IP and Packet Content. Each entry will open a new and unique window, as shown in the
examples below.
Figure 9- 7. CPU Interface Filtering Table – Ethernet
To create a new rule set for an access profile click the Add button. A new window is displayed. To remove a previously created
rule, click the corresponding
button. The following window is used for the Ethernet Rule configuration.
Figure 9- 8. CPU Interface Filtering Rule Configuration – Ethernet
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters Description
Profile ID
This is the identifier number for this profile set.
107
To Next Page
Loading...
