DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
123
delete link_aggregation group_id
Purpose Used to delete a previously configured link aggregation group.
Syntax
delete link_aggregation group_id <value 1-6>
Description This command is used to delete a previously configured link
aggregation group.
Parameters
<value 1-6> Specifies the group ID. The Switch allows up to 6 link
aggregation groups to be configured. The group number identifies
each of the groups.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To delete link aggregation group:
DES-3028P:4#delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DES-3028P:4#
config link_aggregation
Purpose Used to configure a previously created link aggregation group.
Syntax
config link_aggregation group_id <value 1-6
> {master_port <port>
| ports <portlist> | state [enable | disable]
Description This command allows users to configure a link aggregation group that
was created with the create link_aggregation command above.
Parameters
group _id <value 1-6> Specifies the group ID. The Switch allows up
to 6 link aggregation groups to be configured. The group number
identifies each of the groups.
master_port <port> Master port ID. Specifies which port (by port
number) of the link aggregation group will be the master port. All of the
ports in a link aggregation group will share the port configuration with
the master port.
ports <portlist> Specifies a port or range of ports that will belong to
the link aggregation group.
state [enable | disable] Allows users to enable or disable the
specified link aggregation group.
Restrictions Only Administrator-level users can issue this command. Link
aggregation groups may not overlap.
Example usage:
To define a load-sharing group of ports, group-id 1,master port 1 with group members ports 1 through 4:
DES-3028P:4#config lin
To Next Page
Loading...
