D-Link DES-3052P - 802.1 x Authenticator Settings

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
148
21
802.1X COMMANDS
The DES-3028/28G/28P/52/52P implements IEEE 802.1X Port-based and Host-based Access Control. This mechanism is
intended to allow only authorized users, or other network devices, access to network resources by establishing criteria for each
port on the Switch that a user or network device must meet before allowing that port to forward or receive frames.
Command Parameters
enable 802.1x
disable 802.1x
show 802.1x auth_state {ports <auth_portlist>}
show 802.1x auth_configuration {ports <auth_portlist>}
config 802.1x capability ports [<auth_portlist> | all] [authenticator | none]
config 802.1x auth_parameter ports [<auth_portlist> | all] [default | {direction [both | in] | port_control
[force_unauth | auto | force_auth] | quiet_period <sec 0-65535> |
tx_period <sec 1-65535> | supp_timeout <sec 1-65535> | server_timeout
<sec 1-65535> | max_req <value 1-10> | reauth_period <sec 1-65535> |
enable_reauth [enable | disable]}]
config 802.1x auth_protocol [radius_eap | local]
config 802.1x init {port_based ports [<auth_portlist> | all] | mac_based [ports]
[<auth_portlist> |all] {mac_address <macaddr>}]
config 802.1x auth_mode [port_based | mac_based]
config 802.1x reauth {port_based ports [<portlist> | all] | mac_based [ports] [<portlist> | all]
{mac_address <macaddr>}]
config radius add <server_index 1-3> <server_ip> key <passwd 32> [default | {auth_port
<udp_port_number 1-65535> | acct_port <udp_port_number 1-65535>}]
config radius delete <server_index 1-3>
config radius <server_index 1-3> {ipaddress <server_ip> | key <passwd 32> [auth_port
<udp_port_number 1-65535> acct_port <udp_port_number 1-65535>]}
config radius parameter { timeout <int 1-255> | retransmit <int 1-255>}
show radius
create 802.1x guest_vlan <vlan_name 32>
config 802.1x guest_vlan ports [<portlist> | all] state [enable | disable]
delete 802.1x guest_vlan {<vlan_name 32>}
show 802.1x guest_vlan
show auth_statistics {ports <auth_portlist>}
show auth_diagnostics {ports <auth_portlist>}
show auth_session_statistics {ports <auth_portlist>}
show auth_client
show acct_client
create 802.1x user <username 15>
delete 802.1x user <username 15>
show 802.1x user